Baxi Fires Division 347 Manuel de service télécharger pdf (Page 110)

8.23 Fault

Fault message

(6700)

A current existing error in the system is displayed here in the form of an error

code.

SW diagnostic code

(6705)

In case of a fault, the display fault is on permanently. In addition, the diagnosis

code is displayed on the display.

Fault phase

(6706)

The phase in which the fault has occurred, which led to the failure.

Reset alarm relay

(6710)

An output relay QX, programmed as an alarm relay can be reset via this setting.

Temperature-Alarms

(6740-6745)

Setting the time, after which a error message will be triggered in case of persist-

ing deviation from temperature nominal and actual values.

Error history/error codes

(6800 - 6995)

The last 20 error messages with error code and time of error occurrence will be

stored in the error history.

8.24 Service / special operation

Burner hours interval

(7040)

Setting of the interval for maintenance of the burner.

Burn hrs since maintenance

(7041)

Burner hours since the last maintenance.

Note: The burner hours are only counted, when the maintenance message has

been activated.

Burner start interval

(7042)

Setting of the interval for burner starts for maintenance.

Burn starts since maint

(7043)

Burner starts since the last maintenance.

Note: The burner starts are only counted, when the maintenance message has

been activated.

Maintenance interval

(7044)

Setting of maintenance interval in months.

Time since maintenance

(7045)

Passed time since the last maintenance interval.

Note: The time is only counted, when the maintenance message has been activa-

ted.

Fan speed ionization current

(7050)

Speed limit from which the ionisation current service alarm should be set (prog.

no. 7051), if the ionisation current monitoring and therefore a speed increase

based on too low ionisation current active is.

Message ionization current

(7051)

Function for display and reset of the burner ionisation current service alarm. The

service alarm can only be reset if the reason for service is taken care of.

Chimney-sweep function

(7130)

The chimney sweep function is switched on or off under this program number.

Note:

The function is switched off by the setting "Off" or automatically if the maximum

boiler temperature is reached.

It can also be directly activated via the chimney sweep button.

Programming

110 Paramount three 30-115 kW 396532 07.11

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 135 136

Commentaires sur ces manuels

Pas de commentaire

Baxi Fires Division 347 Manuel de service Page 110

Commentaires sur ces manuels

Produits connexes et manuels pour Chauffages d'appoint Baxi Fires Division 347