Baxi Fires Division 347 Manuel de service télécharger pdf (Page 125)

10.7 Disassembling heat

exchanger

The following work has to be carried out, if the heat exchanger has to be fully dis-

assembled:

Note:

The gas burner must be removed (see section Removing the gas burner).

1. Close shut-off valves of flow and return.

2. Drain off boiler water

3. Loosen plugs of boiler sensors (flow and return).

Loosen screw connectors of flow and return (1 and 2) at the heat exchanger

(flat seal)

5. Remove auto-de-aerator.

6. Pull off cable from water pressure monitor.

7. Undo fitting at the pump replacement pipe and remove the pipe

Paramount three 60: Remove return pipe.

9. Paramount three 60: Pull off plug from gas valve, loosen and disassemble gas

valve.

10. Paramount three 95/115: Remove the connection line between the heat ex-

changer and the collecting tray

11. Paramount three 95/115: Push the slide coupling on the flue pipe upwards

12. Loosen nuts at collecting tray, remove yoke and disassemble collecting tray.

13. Loosen nuts of holding sheet at the rear wall, lift heat exchanger from the rear

wall and take out.

14. For cleaning the heat exchanger, rinse with soft water jet (without additives).

10.8 At the end of the

maintenance work

- After finishing the cleaning work, re-install heat exchanger and burner.

- Check the nominal heat load and exhaust gas values.

Maintenance

396532 07.11 Paramount three 30-115 kW 125

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 135 136

Pas de commentaire

Baxi Fires Division 347 Manuel de service Page 125